03-08-2024, 05:41 AM
Just to reiterate (and set expectations) this was more a heads up rather than definitive problems. My MQTT knowledge is severely limited. There are a few widgets that connect to MQTT, but since the board isn't even hooked up, they just stay blank. I haven't even reset my server (gotta dig through files to remember what program I used lol) and that might be all that's required. Basically, I experienced the 5 second click to reaction lag, traced it to the MQTT reconnection loop, disabled it, no more lag, got on here and reported it. I wanted to report it JUST INCASE it was a bigger issue.
That being said, the program/connection was working fine in 0.6.18 before the auto update on my laptop. My desktop still has 0.6.18 and shows a healthy connection to the MQTT server (same copy of program on both machines). I don't have my laptop at the moment, but I will attempt to reset the MQTT server tonight and check on it tomorrow.
Did you notice any issues with the minimize, maximize, and close buttons on your end?
That being said, the program/connection was working fine in 0.6.18 before the auto update on my laptop. My desktop still has 0.6.18 and shows a healthy connection to the MQTT server (same copy of program on both machines). I don't have my laptop at the moment, but I will attempt to reset the MQTT server tonight and check on it tomorrow.
Did you notice any issues with the minimize, maximize, and close buttons on your end?