12-20-2023, 08:01 AM
Hi Ilias,
is it possible to get a Rotary Encoder
( these units which you can turn endless in one ore the other direction)
in one of the next version?
It should be similar to your Rotary switch without the need of position values,
but also with:
start angle
angle between position (e.g. 3.6° for 100 steps per rev)
additionally:
each step should add/subtract a value (taken from a variable) to the output variable.
a selectable image (like the Regulator)
I could really use this!!
Cheers, Joe
is it possible to get a Rotary Encoder
( these units which you can turn endless in one ore the other direction)
in one of the next version?
It should be similar to your Rotary switch without the need of position values,
but also with:
start angle
angle between position (e.g. 3.6° for 100 steps per rev)
additionally:
each step should add/subtract a value (taken from a variable) to the output variable.
a selectable image (like the Regulator)
I could really use this!!
Cheers, Joe